Cargo Tie-Down Anchors, 10PCS V-Ring 2" Diameter Steel V-Ring Bolt On Trailer Anchor for Cargo on Trucks Pickups Trailers Flush Mount TieDown Anchor

Durable and strong with good finish.I removed bolts that mount my Polaris Ranger bed and put the bolt through the attachment point. Worked great. Also comes with screws and washers if you want to mount it that way.

The media could not be loaded. I was in need of something that will accommodate the stock hooks on my 1990 Nissan D21 pickup. And these were the best. Other than the screws being a bit too long they did the job anyway by securing the hooks solidly. I used a 1/16 " inch drill bit as a starter hole and followed it with a 5/32" inch bit, these will hold the screws tightly.

Large and strong

The rings themselves were very nicely machined and sturdy.The screws supplied most likely would be ok to use if attaching the rings to a wooden surface. I needed to attach them to a metal trailer railing and had to buy 8 3/8 inch bolts and locknuts. I drilled the corresponding holes and they were fine after torquing them down. They should have supplied the bolts also.But overall it still is a good sturdy product..

The holes are the perfect size for the bed bolts on a 2019 Toyota Tacoma. No drilling required. You need a T55 Torx Bit Socket for the bed bolts. I found the socket for $2.78 at my local "orange, big box, national hardware store everyone hates". Check their website to find the exact isle and bay so you don't have to wonder around and ask someone who knows less than you. Go to the hardware store that shows the most in stock on their website. If they show one or two in stock it is likely they are lost already.The bed bolt has a large washer on it that you need to remove and reinstall once you put these anchors on the bolt. To remove the factory washer you will need to grind down the retention grooves on the bolt itself. This can be easily done with a dremel or even a regular file if you don't mind taking a little longer. With my dremel it took less than a minute per bolt. Once you take the washer off you install these anchors with the flat side down and reinstall the factory washer (sandwich the anchor). Then just reinstall the bolt to your bed. The torque spec for the bed bold I found online was 50-60 ft lbs. You can find a lot of information about this mod online at tacomaworld.

Search YouTube for "Toyota Tacoma extra D loop tie" and you'll see a video on how these can be installed onto the factory bed bolts for your Tacoma. Works great and now there are more & stronger tie-down anchor points in the bed of the Tacoma.As far as getting them oriented in the correct position/angle, tighten them down all the way and take note of the orientation of the D-Rings. Estimate how much they will need to be rotated in order to face the desired direction. Then back the bolts off just enough so that you can reorientate the D-Rings, compensating for how much they will rotate when tightening again. This might take a couple tries, but once you get the hang of the first one, the rest will be easy to get facing the desired direction.Cheers!

So these heavy duty black tie downs work great on the Maverick tailgate to replace the bottle openertie down. I glued a small rare earth magnet to the tailgate to keep the ring from moving , but it stayedflat without it. I do recommend a flat fender washer ( painted black) if you use the original tie down screw.

Good hooks