by Walking Slow-2x Piece of USB Charging Port Dock Flex Board Replacement for Motorola Moto G 3rd GEN G3 XT1541 XT1540

Right out of the bag one was DOA. See picture. It could not possibly work. One contact was gone and one contact was so severely bent that could not work. This is an utter quality control failure. With one down lets look at the other.The other part in the pack suffers from the a lack of mechanical solder. (Actually every thing wrong with the second was wrong with the first also) A USB port like this has 9 solder joints. 5 are electrical and 4 are just there to hold it to the board. Of those 4, two had no solder at all and two had maybe half the solder they should. This lack would lead to early mechanical failure which in turn would cause electrical connection failure and the premature loss of the ability to charge the phone, again. There is a missing component, I believe it is a capacitor to ground, that was not installed don either board. I can think of about three valid circuit reasons it might be there and none why you would leave it off since they are bought for less than a penny each.All that said. I put some additional solder on the board and installed it and it worked fine. he only reason I went with this seller was delivery time. I have used another seller for this item before and they had a better product except for the PCB thickness which is fine if you leave out the shim. Not one star because I have a special set of skills such that i could make one work. The general population would give zero or one stars. (Why stars, if it is junk I want to rate it in lumps of coal, or prunes, or dog turds)TLDR:Half of them work, just barely.

It is great. Works great and you can't beat Amazons shipping.

My phone wouldn't charge and this part fixed it just fine! :)

I can't say I used it but if I can the screw then I probably would have worked.

Fit and function are just as advertised.

What can you say about power connectors but that they work. Very easy to install.

These are not like the OEM. They break right away. The actual jack breaks away from the circuit board. Keep looking. :(

Works greatYou need to take the metal piece off of the old charging port and attach it to your new one for it to work

PCBs I received were missing the tiny capacitor. Also, the USB connectors weren't a proper fit for the PCB as they had no thru-hole mounting pins. I ordered two PCBs and one had a crooked connector and as it was would not quite fit into the phone. Fortunately, I'm an electronics repair guy so I had the equipment needed to resolder the connector. I bought BisLinks boards and they did have the capacitor and a proper USB connector. I recommend that one over this one. However, if you are in a hurry, the Walking slow boards arrived very quickly and they did install and fix my phone to working order.