Bushwacker Max Coverage Pocket/Rivet Style Front & Rear Fender Flares | 4-Piece Set, Black, Smooth Finish | 40978-02 | Fits 2014-2018 Chevrolet Silverado 1500/2500 HD/3500 HD (Excludes Dually)

still trying to figure out some way to get them to fit my vehicle profile snugly. Fastening system doesn't seem to work well to move or hold the flare in a position where it is snug up against the sheet metal. I'm going to see if I can rig some thing up to move and hold them where they need to be. Look nice on my truck just not to happy with the fit.

Overall a great set and looks great once in place. First the Pros - (1) good quality product, (2) easy to follow instructions included, (3) Amazon selling just below market average, (4) 1 person can install in about 1-2 hoursNow the Cons - Hardest things i found in this install were (1) tiny rubber seal is a pain to put on, can be very time consuming and hurts the fingers, (2) if you have a 14-15 Silverado (like I do) the front bottom pieces may need additional trimming/re-drilling of bolt holes to main pieces for good alignment, (3) you may have to really push in on bottom of the flares and/or drill at an angle to get the screws into a good position in the fender, (4) May require some drilling in some areas (lower sides) but does include enough self-tapping screws to install.

make sure you install them when they are warm out in the sun to make i easier, and give yourself some time to get it done. be patient.

Color match is perfect. They are difficult to install. They look good installed. Here is the BUT....for the price, they should come with a template for drilling. Also, the rubber gasket would NOT seat on one of the four flares, even after we removed it and reinstalled it. We are both very detail oriented, and really took our time to do the installation correctly. It took the two of us close to 6 hours to install these.

I painted the Bushwackers to match my Summit White 3500HD. Installation was pretty easy, but I was a little nervous drilling into my new truck. When fitting the flares and establishing the drilling locations, I was concerned that the edges wouldn't get fully pressed into the side of the body. However, after installing them, they fit snugly and look great. Installation took about 2 hours, working methodically to make sure it was done right. Before mounting, I sealed the holes to try to prevent rust. They add a good level of protection with the wider wheels that are installed.

Nice guards, but the paint did not match my truck

It took a few hours to get this project done.. I scratched the first flare trying to get the rubber trim on it. The trim is an absolute pain, and I can't understand why a $300 chunk of plastic can't come with this already attached. The fitment on my 2016 Silverado was so-so, and definitely required 2 people to hold/drill, etc. You have to be careful that the rubber gasket doesn't get folded under when attacking, or you'll find yourself trying to wrestle it back flush with the flare. Complete pain in the neck. To the point where I wouldn't wouldn't buy these again for the $337 I paid, nor would I ever recommend them to my friends. If they didn't look nice, I probably wouldn't give them any stars.

Rugged, perfect fit and make the truck look very mean! I have always wanted a set of these on my truck and I am so happy I finally bought some. Made in USA and great quality, you can't go wrong with these

Install instructions call for predrilling holes. It was very hard to get marks to be seen on inside of fender well. Resorted to one person holding and pushing tight to fender and install self tap screws. It turned out OK in the end.

Great customer service. Looks awesome on our truck!

Description said no drilling required. Instructions say to drill holes in fender. Disappointing for sure as this will increase risk of corrosion